#Massive layer shifting problems

1 messages · Page 1 of 1 (latest)

hollow hollow
#

I have a flash forge Adventure 4, and use flash print to slice. It does not happen on every print, but it happens every time on the longer ones. Sometimes it's just a few millimetres, sometimes it could be 50. I have factory reset the machine, the belts are tight, I have no idea what to do. Help is much appreciated!

deft graniteBOT
#
AI Help

It sounds like you may be experiencing layer shifting during your prints. This could be caused by a few different factors such as loose belts, improper slicer settings, or mechanical issues. Here are a few troubleshooting steps you can try:

  1. Check belt tension: Make sure all belts are properly tensioned and not slipping during the print.
  2. Calibrate your printer: Ensure that your printer's axes are properly calibrated and moving smoothly without any obstructions.
  3. Check your slicer settings: Verify that your slicer settings are appropriate for your printer and filament. Pay attention to print speed, acceleration, and retraction settings.
  4. Check for mechanical issues: Inspect your printer for any loose screws or parts that may be causing the shifting.

If the issue persists after trying these steps, you may want to reach out to FlashForge customer support for further assistance.

WARNING: This response is AI generated and may contain errors.
hollow hollow
#

Slicer settings are exactly the same as when it worked fine

plush cloak
#

i had that issue, i tightened my belts and it stopped @hollow hollow

#

also if theres some sort of jerk protection it wouldnt hurt to use that

deft graniteBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

hollow hollow
plush cloak
#

its self explanatory