#PLA Clogging

1 messages · Page 1 of 1 (latest)

fathom knot
#

My Ender 3v2 is clogging after 5-10 minutes of printing. The fan speed is all the way up and the problem still occurs.

mellow daggerBOT
#
AI Help

It sounds like you may be experiencing heat creep, where heat travels up through the hot end and causes filament to soften too early. To troubleshoot, make sure your hot end is properly assembled and that the heat sink is clean and has good airflow. You can also try reducing the printing temperature slightly to see if that helps. If the issue persists, you may need to consider upgrading your hot end or replacing any worn out parts.

WARNING: This response is AI generated and may contain errors.