blobs being created

[silent helm]

Every time I go to print these blobs form. The nozzle then runs them over. I tried a new nozzle what else could I do.

[sinful violet]

AI Help

It sounds like you may need to recalibrate your print bed to ensure it is level. Uneven bed leveling can result in poor adhesion and misprints. Additionally, check your filament settings to make sure they are correct for the type of filament you are using. You may also need to adjust your printing temperature or speed to prevent blobs from forming. If the issue persists, it could be a problem with your slicer settings, so double-check those as well. Good luck troubleshooting!

WARNING: This response is AI generated and may contain errors.

[pure lark]

Level the bed.

And make the nozzle temp a little bit cooler.