Bambulab p1s homing issue

[wind falcon]

Hi, when starting a print on my p1s the printer doesnt home correctly and stays in the middle back. Manual homing via interface works like a charm. Nothing is blocking a thing. What to do?

[edgy cave]

AI Help

It sounds like there may be an issue with the printer's configuration or settings. I recommend checking your printer's firmware settings to ensure that the correct homing procedure is configured. Make sure the endstops are properly connected and functioning. You may also need to recalibrate or adjust the printer's homing settings in the firmware. If the issue persists, consider reaching out to the manufacturer for further assistance.

WARNING: This response is AI generated and may contain errors.

[lament pasture]

Do the motors work? Can you move the printhead around by hand in an unpowered state? Feel for bindimg on the axis'

[wind falcon]

Yes, because when clicking on home in bambulab software it does go home perfectly. Also i can move them freely yes

[lament pasture]

good to know.....does the print eventually start?

[wind falcon]

Nope. It stops over here. Let me send a video

[lament pasture]

that wiggling supposed to happen?

[wind falcon]

yes, then he is going to do bed leveling. I will make a video what the normal homing would be

[lament pasture]

and then its just stuck there?

heated and everything?

tried a different print?

[wind falcon]

This is normal honing process. Now going to start print again.

[lament pasture]

tried a different file?

[wind falcon]

Yes, started new file with other stl and same thing

[lament pasture]

any error messages?

SD card or cloud?

[wind falcon]

Cloud and yes got this.

[lament pasture]

should have started with this instead of letting me faff about with everything else.......

cool theres your solution, presented by your printer

whats your question?

[wind falcon]

Yeah but already tried everything in this and still got the error haha

So thats why i got here

[lament pasture]

If you want someone to help you you give ALL the information...

do what it says, if that does not work contact support

good luck

[wind falcon]

Haha oke. Thanks for doing nothing 🤪
Already contacted support and did everything it says...

[lament pasture]

likewise