Extrusion issues | 3D Printing | Page 1

past zodiac Jun 10, 2024, 5:11 PM

#

I recently added the cr touch and a flex plate. But even before that I've been having extrusion issues. Right now it seems like it's over extruding. I adjusted the settings to try to fix it but it made the left side worse.

olive sandalBOT Jun 10, 2024, 5:11 PM

#

past zodiac I recently added the cr touch and a flex plate. But even before that I've been h...

#

AI Help

It sounds like you may need to recalibrate your extruder steps and flow rate. Make sure your nozzle is clear of any clogs or debris, as that can also lead to over-extrusion issues. Additionally, double-check your slicer settings to ensure they are configured correctly for the CR Touch and flex plate modifications. If the issue persists, you may need to revisit your printer's extruder assembly for any potential mechanical issues.

leaden moon Jun 10, 2024, 6:59 PM

#

damn thats some ender 3 quality right there

#

has it always done that?

past zodiac Jun 10, 2024, 7:45 PM

#

No, it used to have super good quality, it started recently

#

Oh, I should probably mention it's a ender 3 v2

olive sandalBOT Jun 10, 2024, 9:47 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

past zodiac Jun 13, 2024, 1:27 AM

#

Still having issues. I changed the filament just in case, but the problem persists. It just likes to suddenly drop a bunch of filament in places it just needs a dot of, but when in motion it prints just fine

#Extrusion issues