#K1 Creality Filament problem

1 messages · Page 1 of 1 (latest)

rancid dagger
#

I just refilled my filament and at the same time change the location of where the filament inserter goes in and its not doing it job and I just got it can someone help

outer treeBOT
#
AI Help

It sounds like the filament may not be feeding properly after refilling it and changing the location. Here are a few troubleshooting steps you can try:

  1. Check the filament path to ensure it is not blocked or tangled.
  2. Make sure the filament is inserted correctly and fully seated in the extruder.
  3. Check the extruder tension to ensure it is properly gripping the filament.
  4. Verify that the filament is the correct diameter for your printer.
  5. Check the extruder gear for any debris or damage that may be preventing proper feeding.

If you continue to experience issues, I recommend referring to your printer's manual for specific instructions on troubleshooting filament feeding problems.

WARNING: This response is AI generated and may contain errors.
rancid dagger
outer treeBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

desert venture
#

You might want to try manually extruding to make sure it’s not a clog

hard halo
#

And make sure the gears actually grab the filament.

#

Do yourself a favor and get the guide tube out of the cable chain and ziptie it to the top of it

rancid dagger
#

why???

hard halo
#

Less of a sharp turn into the extruder

rancid dagger
#

still confused

hard halo
#

More curve means more friction meas more restriction in the filament path.

rancid dagger