kobra 2 homing fail | 3D Printing | Page 1

mental scroll May 12, 2024, 2:40 AM

#

I try to move x axis to 0 point and it tries to keep going left when it cant go further. need help

viscid baneBOT May 12, 2024, 2:40 AM

#

mental scroll I try to move x axis to 0 point and it tries to keep going left when it cant go ...

#

AI Help

It sounds like you may need to adjust the endstop or homing settings for the x-axis on your 3D printer. Check to make sure the endstop is triggered when the x-axis reaches its 0 point. You may need to adjust the endstop position or the firmware settings to ensure the x-axis stops correctly at its home position.

robust cove May 12, 2024, 6:21 AM

#

Im not familiar with the Kobra 2 but typically it looks like the end stop switch isnt working / being contacted by the print head. Power off the machine then move the X axis manually to the left to make sure the switch is being pressed

#

This switch

#kobra 2 homing fail