Messing up

[grand finch]

Can someone help me with my Ender 3 VESE Messing up? I'm trying to print helmets and they wont stick sometimes. My red hood helmet worked fine (But too small) then I'm trying to print the back piece of my Cyclops helmet/mask and it keeps messing up, i have my bed all clean and calibrated but i still don't know what wrong.

[civic kettle]

AI Help

It sounds like you may be experiencing adhesion issues with your prints. Here are a few troubleshooting steps you can try:

1. Ensure that your print bed is level and properly calibrated. Use a piece of paper to check the distance between the nozzle and the bed at all four corners and adjust as necessary.
2. Clean the bed surface with isopropyl alcohol to remove any oils or debris that may be affecting adhesion.
3. Try adjusting the bed temperature. For materials like PLA, a bed temperature of around 60-70°C usually works well for adhesion.
4. If the issue persists, you may want to consider using a brim or a raft for your prints to provide additional adhesion.

If you continue to experience issues, feel free to provide more details, and I can try to help further.

WARNING: This response is AI generated and may contain errors.