artifacts on outer wall | 3D Printing | Page 1

nocturne panther May 6, 2024, 5:53 AM

#

I keep getting these artifacts. I've tried different temps, drying my filament, slowing my print down, switching to outer/inner wall print, increasing fan speed, filament roll in a dryer box now.

Also checked the extruder gear and isn't caked.
Prints fine on a friend's P1S

Bambu A1 Mini
Polysonic PLA Pro
Tried Bambu PLA and Polymakers online filament profiles

analog barnBOT May 6, 2024, 5:53 AM

#

nocturne panther I keep getting these artifacts. I've tried different temps, drying my filament, ...

#

AI Help

It sounds like you've already tried a variety of troubleshooting steps. Since the prints are turning out fine on your friend's P1S, it could potentially be a specific issue with your printer. Have you checked the belt tension, bed leveling, and overall calibration of your Bambu A1 Mini? It's also worth examining the slicer settings and making sure they are correctly configured for your printer. If the issue persists, it may be helpful to reach out to the manufacturer for further assistance.

signal steeple May 6, 2024, 6:13 AM

#

That's the seam

#

it is where the printer start and stop

#

each section have one

#

a finelly tuned machine can reduce but can not eliminate the seam

nocturne panther May 6, 2024, 7:05 AM

#

not talking about seam. the stringing on the walls are little thicker than regular stringing i can't just melt off

#artifacts on outer wall