#any idea what’s wrong?

1 messages · Page 1 of 1 (latest)

twilit orbit
#

Printer: Sovol Sv06 Klipper
Slicer: Cura
Filament: PLA

First layer looks really good, but as soon as it starts the infill it looks like the photos attached.

IMG_7691.jpg IMG_7689.jpg IMG_7688.jpg
mighty flaxBOT
#
AI Help

It seems like you are experiencing under-extrusion issues. Here are some troubleshooting steps you can try:

  1. Check the filament diameter setting in Cura and make sure it matches your actual filament size (usually 1.75mm for PLA).
  2. Ensure the nozzle is not clogged by doing a cold pull or nozzle cleaning.
  3. Check the extruder gear and make sure it is clean and free from dust or debris.
  4. Adjust the extrusion multiplier in Cura to increase the flow rate if needed.
  5. Make sure the hotend temperature is set correctly for PLA (around 200-220°C).
  6. Check the filament spool for tangles or knots that may cause feeding issues.
  7. Try printing at a slightly higher temperature to improve layer adhesion.

If the issue persists, feel free to provide more details for further assistance.

WARNING: This response is AI generated and may contain errors.