How to remove stuck filament in the nozzle

[covert maple]

I havent used my printer in a while and was trying to fix the filament cuz it had dropped off its little holder thing and was twisted, so i tried pulling it out of the printer but it was stuck and snapped off, then i took off the tube part and tried pulling it out again just for it to snap once more and now its stuck fully in the tube with no way to grab it with tweasers, how do i get it out?

[grand surge]

AI Help

You can try using a small drill bit or a thin piece of wire to push the filament out from the other end of the tube. Alternatively, you can try heating up the tube gently with a hairdryer to soften the filament and then attempt to push it out. Be careful not to damage the tube in the process. If these methods do not work, you may need to replace the tube.

WARNING: This response is AI generated and may contain errors.

[latent belfry]

yeah so whenever you pull out fillament you gotta heat up the nozzle first. what i would suggest is to heat up the nozzle and push though another peice of fillament though until it poops it all out then pull it back out