#My prints keep coming out with layering problems any ideas how to fix this

1 messages · Page 1 of 1 (latest)

high bladeBOT
#
AI Help

It sounds like you may be experiencing issues with print adhesion or bed leveling. Here are some steps you can take to improve your prints:

  1. Check your bed leveling: Make sure your bed is leveled properly before starting each print. Use a piece of paper or a feeler gauge to adjust the distance between the nozzle and the bed at each corner and the center.

  2. Check your nozzle height: Ensure that your nozzle is not too close or too far from the bed. Adjust the z-offset if needed to get the ideal first layer.

  3. Clean your build surface: Ensure that your build surface is clean and free of debris. You can use isopropyl alcohol to clean the build surface before each print.

  4. Adjust your print settings: Make sure your print settings are optimized for your filament type and model. You may need to adjust your print temperature, print speed, and retraction settings.

  5. Calibrate your extruder: Make sure your extruder is calibrated properly to ensure the right amount of filament is be...

WARNING: This response is AI generated and may contain errors.
crystal walrus
#

I’ve tryed all of those already

#

Need help from a real human please anyone ?

bleak ivy
crystal walrus
#

It came with it

high bladeBOT
# crystal walrus It came with it

Calibration
Calibration and tuning can help with all aspects of print quality.
Extruder calibration should be done only once, and then again if you change any hardware on your extruder setup (new tube, gear drive, different motor, etc).
Flow calculation should be done for every filament, even different colours from the same brand.

A number of calibration and tuning guides exist online:

?calibration requested by: m.von.d#0
bleak ivy
#

Follow the guides, you have some convoluted problems going on. By following a guide you can eliminate most of the stuff

crystal walrus
#

thats really no help but okay ive tried everything ik