Need help filling a huge gap.

[scenic quail]

I am working on this prop print and the two pieces that are suppose to be touching have a huge gap where the print messed up as. Does anybody know a good way to fill large gaps that I can sand down?

[muted mist]

AI Help

You can use a filler material like an epoxy resin or Bondo to fill in the gap. Allow it to cure fully, then sand it down to create a smooth surface. Just be sure to wear appropriate safety gear and work in a well-ventilated area when using these products.

WARNING: This response is AI generated and may contain errors.

[icy scarab]

^

[scenic quail]

You have a recommendation for a type of bonds because the stuff I’m using now seems like it would be a lot to fill that

[muted mist]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[crisp mist]

you should just reprint the right side, the corners dont line up so the filling is going to be so jenky

but to do filing over huge gap you want to out down tape first then use a thicker large hole wood filler

[clever lark]

"Bondo" is a product name. Car body filler. You can create a shell with duct tape and apply the filler

Like polaris said