Adhesion issues?

[crisp root]

I am having some problems with my qidi x plus 3. I just set the z-axis, leveled the bed before the print, and washed the bed however prints are coming off and spaghettifying. I look at it and it seems the bed is going down more than it should on the first layer and thus nothing is printing right but this only happens about halfway through the first layer. What should I do?

[sacred jacinth]

AI Help

It sounds like you may be experiencing adhesion and leveling issues. Here are some steps you can take to troubleshoot:

1. Check the leveling of the bed again, ensuring that it is properly leveled and not too close to the nozzle.
2. Consider adjusting the Z-offset to make the first layer adhere better to the bed.
3. Make sure the bed surface is clean and free of any debris or residue that could affect adhesion.
4. Ensure that your print settings are appropriate for the material you are using, such as the correct first layer height and printing temperature.

If you have tried these steps and are still experiencing issues, you may want to reach out to Qidi Tech's customer support for further assistance.

WARNING: This response is AI generated and may contain errors.