BLTOUCH error | 3D Printing | Page 1

lofty goblet Apr 18, 2024, 4:18 PM

#

why does my printer not home? the bl touch seems to work just fine but the motor just wont move it down when its supposed to home Z axis even tho the probe deploys

simple plumeBOT Apr 18, 2024, 4:18 PM

#

lofty goblet why does my printer not home? the bl touch seems to work just fine but the motor...

#

AI Help

It sounds like there may be an issue with the configuration or wiring of your 3D printer. I recommend checking the connections between the BLTouch probe, the Z-axis motor, and the controller board. Make sure they are properly connected and secure. You may also need to adjust the settings in your printer's firmware to ensure that the Z-axis homing process is configured correctly. If you continue to experience issues, I suggest reaching out to the manufacturer of your 3D printer for further assistance.

simple plumeBOT Apr 18, 2024, 6:20 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

lofty goblet Apr 18, 2024, 6:32 PM

#

ay

burnt aspen Apr 18, 2024, 6:56 PM

#

As always with bltouch (and friends) double and triple check all wiring

lofty goblet Apr 18, 2024, 6:57 PM

#

burnt aspen As always with bltouch (and friends) double and triple check all wiring

did that

#

probably even more than triple

#BLTOUCH error