#extruder skipping...

1 messages · Page 1 of 1 (latest)

burnt shore
#

Hi, i encounter skipping while extruding white PLA 220C 12 mm³/s with 0.2 mm nozzle

mortal anvilBOT
#
AI Help

Skipping during extrusion can be caused by various factors. Here are some troubleshooting steps you can try:

  1. Check the filament: Ensure that the filament is in good condition and not tangled or stuck. Also, make sure the filament diameter matches the settings in your slicer.

  2. Nozzle blockage: Check the nozzle for any blockages or debris that may be hindering the extrusion. You can try cleaning the nozzle with a nozzle cleaning needle or by doing a cold pull.

  3. Extruder tension: Make sure the extruder tension is set correctly for the filament you are using. Adjust the tension if needed to ensure smooth and consistent extrusion.

  4. Temperature: Try increasing the temperature slightly to see if that helps with the extrusion. Sometimes, a higher temperature may be needed for certain filaments.

  5. Extrusion speed: If you are still experiencing skipping, you may need to adjust the extrusion speed in your slicer settings. Try reducing the speed to a level where skipping does not...

WARNING: This response is AI generated and may contain errors.
burnt shore
#
  1. filament is alright
  2. nozzle is alright
  3. extruder tension is alright
  4. i dont want to go above 220 C
  5. 12 mm³/s should obviously work
#

the thing that is wrong is probably

#

something might be wrong with thermistor

#

idk

#

or maybe motor is working too weak

#

even when i try to push through the hotend with hand its very hard