probe deploys, doesn't stop z

[inland ferry]

AI Help

It sounds like your CR Touch probe is not triggering properly. Here are a few troubleshooting steps you can try:

1. Check the wiring: Make sure all the connections between the probe and the control board are secure and properly connected. Ensure that there are no loose wires or damaged connections.

2. Adjust probe height: Sometimes the probe may not trigger because it is not at the correct height. Adjust the probe height so that it is closer to the bed or nozzle.

3. Check probe settings in firmware: Double-check the configuration settings in Marlin firmware to ensure that the correct probe type is selected and the probe offsets are properly configured.

4. Test probe functionality: You can use a multimeter to test the continuity of the probe when it touches the bed. This can help determine if the probe itself is functioning correctly.

If you have tried these steps and are still facing issues, it might be helpful to reach out to the community forums for additional assistance.

WARNING: This response is AI generated and may contain errors.

[hearty oyster]

what did you follow to install and comple marlin?

[inland ferry]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[summer tinsel]

This video https://www.youtube.com/watch?v=pQ7WZST8sqk

[inland ferry]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.