#Problem with first layer

1 messages · Page 1 of 1 (latest)

chilly crown
#

Hi, i;m beginner in 3D print stuff. I have AnyCubic Kobra 2 Pro and when i print 1'st layer test print (180x180x0.24) it's like on the photos.

  • Stock printer (0.4 extruder)
  • Print temp: 200 C
  • Prusa Slicer
  • PLA
  • software (layer 0.2 / first layer 0.24)
    Help pls
IMG_20240413_210732.jpg IMG_20240414_035451.jpg
keen fogBOT
#
AI Help

It appears that your first layer test print has some issues with adhesion and possibly leveling. Here are a few troubleshooting steps you can take:

  1. Check bed leveling: Make sure your bed is properly leveled. An unlevel bed can result in poor adhesion and print quality. Adjust the bed leveling screws or use automatic bed leveling if your printer has that feature.

  2. Clean the print surface: Ensure that the print surface is clean and free from any debris or oil. You can use isopropyl alcohol to clean the print bed before each print.

  3. Adjust print bed temperature: You can try increasing the bed temperature slightly to improve adhesion. Make sure not to go too high to avoid warping.

  4. Use a brim or raft: Adding a brim or raft to your print can help improve adhesion to the bed.

  5. Check extruder calibration: Make sure your extruder is calibrated correctly to ensure that the correct amount of filament is being extruded.

Give these steps a try and see if they help improve your ...

WARNING: This response is AI generated and may contain errors.