Major stringing | 3D Printing | Page 1

astral narwhal Apr 13, 2024, 4:58 PM

#

Tried a stringing test, but didn’t expect it to come out like this. I leveled my bed correctly. I am using the kp3s pro.

molten girderBOT Apr 13, 2024, 4:58 PM

#

astral narwhal Tried a stringing test, but didn’t expect it to come out like this. I leveled my...

#

AI Help

It looks like your printer settings may need some adjustments. Here are a few troubleshooting steps to reduce stringing on your print:

Check and adjust the retraction settings in your slicer software. Increase the retraction distance and speed slightly to see if it helps reduce stringing.
Ensure that the filament is well-supported and not causing any resistance in the extruder.
Check the temperature settings for the filament you are using. Adjusting the temperature slightly can also help reduce stringing.
Make sure your hotend is properly heated and not experiencing any fluctuations in temperature during the print.

By fine-tuning these settings, you should be able to achieve cleaner and less stringy prints.

strange junco Apr 13, 2024, 4:59 PM

#

wet filament probably if it was working fine before

trim ore Apr 13, 2024, 5:01 PM

#

What range does this test have? what material? Did you tune temperature before?

astral narwhal Apr 13, 2024, 5:17 PM

#

trim ore What range does this test have? what material? Did you tune temperature before?

I’m using PLA and I’ve only preheated the temperature to 200 for the nozzle and 60 for the bed

trim ore Apr 13, 2024, 5:43 PM

#

astral narwhal I’m using PLA and I’ve only preheated the temperature to 200 for the nozzle and ...

Range of retraction?

astral narwhal Apr 13, 2024, 5:52 PM

#

I don’t know, where can I check?

astral narwhal Apr 13, 2024, 6:25 PM

#

retraction distance is 1 mm

#

retraction retract speed: 40 mm/s

astral narwhal Apr 13, 2024, 7:56 PM

#

trim ore Range of retraction?

so what should i do?

trim ore Apr 13, 2024, 8:44 PM

#

astral narwhal so what should i do?

So you ran the retraction tower with unknown values or was it only a test at a single retraction distance?

molten girderBOT Apr 13, 2024, 8:44 PM

#

Teaching Tech Calibration Guide
Teaching Tech

trim ore Apr 13, 2024, 8:45 PM

#

Follow the guide and keep the order of the steps

astral narwhal Apr 13, 2024, 9:00 PM

#

trim ore So you ran the retraction tower with unknown values or was it only a test at a s...

I just printed it

#

@trim ore thank you so much, I’m watching the video right now just skipping to retraction. I will update you once I print it. At the moment it is raining

#Major stringing