#What is limiting my print speed?

1 messages · Page 1 of 1 (latest)

rigid spire
#

I have my speed set to 150 mm/s and accel set to 3500mm/s^2. My printer is visibly a lot faster, but my slicer still outputs a print time of 1 hour and 26 minutes. The cura config is pretty much the same as the stock config with a few modifications made, what do I need to change to achieve higher speeds?

image.png
midnight mesaBOT
#
AI Help

If you have already adjusted the speed and acceleration settings on your printer, the next step would be to check your slicer settings. Make sure that the print speed settings in your slicer software match or exceed the speed settings on your printer. You may also want to adjust the travel speed, acceleration, and jerk settings in the slicer to align with the capabilities of your printer. Additionally, ensure that your print quality settings are not limiting the speed of the print. Making these adjustments should help you achieve higher print speeds.

WARNING: This response is AI generated and may contain errors.
rigid spire
#

I've discovered minimum layer time, and after tuning it, another 8 minutes have been shaved off my print

#

and after tuning jerk, my benchy print speed is down to 1 hour and 3 minutes