#support keeps detaching from bed

1 messages · Page 1 of 1 (latest)

signal remnant
#

My supports keep detaching and idk why

pulsar leafBOT
#
AI Help

It sounds like your supports might not be adhering properly to the build plate or the model. Make sure your build plate is clean and properly leveled. You can also try increasing the support density or adding a brim to improve adhesion. Additionally, using a higher-quality support material or optimizing support settings in your slicing software can help prevent detachment issues.

WARNING: This response is AI generated and may contain errors.
onyx pasture
#

did you try a brim?

#

also are you in cura?

signal remnant
onyx pasture
#

Welp back to the top then
Clean bed with soap and warm water
Z offset and first layer print
ABL
then if all these dont work stare at the printer and see if its hitting the supports

signal remnant
onyx pasture
#

AUto bed leveling

signal remnant
#

Oh yea okay I guess I can do it again lol

pulsar leafBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

signal remnant
#

It makes like a sound sometimes

pulsar leafBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

signal remnant
#

😭

tough mountain
#

Z offset and maybe flow calibration

#

If it overextrudes it may catch on a previous layer