#block resin stuck on fep

1 messages · Page 1 of 1 (latest)

gleaming cobalt
#

There was a large rectangle of resin solid enough to pull off on the fep, I’m just wondering if this is still good to use or if I need to replace the fep. Also if the resin I had emptied out is still good as it’s just in a container now.

Cheers

IMG_6465.jpg
hexed currentBOT
#
AI Help

If the large rectangle of resin was solidified and pulled off the FEP, it's likely that there won't be any damage to the FEP sheet itself. You can inspect the FEP sheet for any visible damage or scratches. If it appears to be in good condition, you should be able to continue using it.

As for the resin that was emptied out and is now in a container, as long as it has not been exposed to light or air, it should still be usable. Just make sure to filter it back into the original resin bottle before using it again to remove any debris or solidified bits.

If you have any concerns about the quality of the resin or the FEP sheet, it's always a good idea to replace them to ensure smooth printing operations.

WARNING: This response is AI generated and may contain errors.
hexed currentBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

woeful dagger