#Kobra Plus issues with print adhesion

1 messages · Page 1 of 1 (latest)

neat scarab
#

Having issues getting prints to stick consistently to my Kobra Plus bed. Recently replaced the bed itself and ensured all belts/bolts were tight. I've tried multiple runs at Zprobe calibration and Mesh bed leveling, but tend to run into the same issues.

IMG_2404.jpg
vocal swiftBOT
#
AI Help

It sounds like you have already taken some good troubleshooting steps. Here are a few more things you can try to improve bed adhesion:

  1. Make sure your bed is clean: Use isopropyl alcohol to thoroughly clean the surface before each print.
  2. Adjust your initial layer height and nozzle distance: Make sure the nozzle is close enough to the bed for good adhesion, but not too close that it scrapes.
  3. Try different bed adhesion methods: Experiment with different bed adhesion techniques like using a brim, rafts, or adhesive sprays.
  4. Check your filament and print settings: Ensure that you are using the correct temperature for the filament and that your print settings are optimized for good bed adhesion.
  5. Consider upgrading to a different build surface: If you continue to have issues, you may want to explore different build surfaces like PEI sheets or glass beds.

If these suggestions do not improve your bed adhesion, it may be helpful to reach out to the manufacturer for further assi...

WARNING: This response is AI generated and may contain errors.