#Sovol SV06 Underextrusion (?) issues

1 messages · Page 1 of 1 (latest)

calm mist
#

Not totally sure what's going on here - I'm printing with AMZ3D white PLA, print temp is at 210, print speed is at 80mm/s, extruding filament manually works perfectly fine, nozzle isn't clogged from what I can tell, the grub screw in the extruder gear that I've heard is an issue is still tight, I've cleaned out the extruder gears and the extruder tensioner screw is tight, so ????

image.png
flat rainBOT
#
AI Help

It sounds like you've covered a lot of troubleshooting steps already, which is great. One thing to check could be the filament itself - sometimes inconsistencies in filament diameter can cause extrusion issues. You may also want to double-check the PTFE tube and make sure it's seated correctly and not damaged. If everything seems fine with the hardware, you could try adjusting the extrusion multiplier in your slicer settings to see if that helps improve extrusion.

WARNING: This response is AI generated and may contain errors.