Ender 5 dead? | 3D Printing | Page 1

neon cloak Feb 25, 2024, 4:16 AM

#

Just to make sure my ender 5 extruder motor stopped work. i swapped the z axis cable and motor to the exturder spot and they dont work. until i swap it back to the correct spot. would i be correct in assuming that the motherboard is well. dead

runic sundialBOT Feb 25, 2024, 4:16 AM

#

neon cloak Just to make sure my ender 5 extruder motor stopped work. i swapped the z axis c...

#

AI Help

It's possible that the issue lies with the motherboard if swapping the cables and motors did not resolve the problem. Before assuming the motherboard is dead, you may want to check for loose connections, ensure the drivers are properly configured, and inspect for any visible damage on the board. If these steps do not resolve the issue, it is likely that the motherboard may need to be replaced.

runic sundialBOT Feb 25, 2024, 6:19 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

summer pulsar Feb 26, 2024, 8:15 AM

#

neon cloak Just to make sure my ender 5 extruder motor stopped work. i swapped the z axis c...

Umm is there any "magic smoke?"

#

have u tried connecting to it w/ a terminal? im concerned w/ the motherboard rn

#

terminal is usb micro to ur computer & use pronterface

#

to send cmds to see if its alive

#Ender 5 dead?