Ender 3 V2 Orca Slicer Time Remain | 3D Printing | Page 1

mortal oyster Feb 21, 2024, 4:05 AM

#

Hello! Recently made the switch from Cura to Orca slicer and I noticed that my time remaining is stuck at 00:00 when I print using a gcode sliced from Orca. Anyone know why this is? Any help would be appreciated.

chilly groveBOT Feb 21, 2024, 4:05 AM

#

mortal oyster Hello! Recently made the switch from Cura to Orca slicer and I noticed that my t...

#

AI Help

Hello! The issue of the print time remaining being stuck at 00:00 could be due to a few reasons. One common reason is incorrect communication between the slicer and the printer firmware, which can sometimes cause inaccurate time estimations. The issue could also be related to how the slicer is calculating and encoding the print time in the gcode file. I would recommend checking the settings in Orca slicer related to print time estimation and also ensuring that your printer firmware is up to date. If the issue persists, you may want to reach out to the Orca slicer community or support for further assistance.

chilly groveBOT Feb 21, 2024, 6:09 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

mortal oyster May 2, 2024, 5:05 AM

#

Bump, still have this problem, 3 months later

#Ender 3 V2 Orca Slicer Time Remain