#SAVE_CONFIG section 'stepper_z' option 'position_endstop' conflicts with included value

1 messages · Page 1 of 1 (latest)

fallen shore
#

I am trying to manually level the bed. I do not have a z probe sensor and cannot use sensorless homing. I want to set my z offset so that it doesnt keep scraping the bed

glossy oracleBOT
#
AI Help

To manually level the bed without a sensor, you can use a piece of paper or a feeler gauge to adjust the distance between the nozzle and the bed. When you move the nozzle close to the bed, it should create a slight friction with the paper but still allow you to move the paper back and forth. Once you've found the right distance, adjust your Z offset in your printer settings to fine-tune the nozzle height. This should prevent the nozzle from scraping the bed during prints.

WARNING: This response is AI generated and may contain errors.
fallen shore
#

This is on klipper

solemn crane
# fallen shore This is on klipper

I'm more familiar with Marlin than klipper so I can't tell you the exact line to change in the firmware, but you should have a Z_probe_offset (not the one you want) and also a Z offset. thats the one you want to mess with so that "0" ends up being right where you want it.

#

this looks like it has the relevant links

zinc pasture
fallen shore
#

only problem, i cant do that

Screenshot_2024-02-19_210103.png
zinc pasture
fallen shore
#

maybe

#

im still getting it

zinc pasture
#

send a klippy log here

#

You have the value included in some config and save_config can only write to printer.cfg

#

Put the offending line into printer.cfg and remove it from the included .cfg

#

Probably in something like stepper.cfg

#

However you set up your system

#

aha here: #✅｜help-quick-questions message

#

Yeah still the same answer

fallen shore
#

what value is it supposed to affect?

#

im not sure what to replace into printer.cfg

zinc pasture
fallen shore
#

im sorry, this is the first time im using klipper

zinc pasture
#

No need to be sorry. I forgot that the klippy log doesn't report included .cfg so I cant find amything in there😅