#prints go off center at around 50-80% completion

1 messages · Page 1 of 1 (latest)

finite yoke
#

Hey all, i’m using an Ender 3 V3 SE, and any time i try to print anything, at around 50-80% completion, my print goes off center. What can i do to mitigate this?

IMG_0039.jpg
snow daggerBOT
#
AI Help

If your print is going off-center after reaching a certain completion percentage, there might be a few things you can check and adjust on your Ender 3 V3 SE:

  1. Make sure that the belt tension on the X and Y-axis is correct. Loose belts can cause the print head to shift during movements. Tighten them appropriately, but ensure they're not overly tight, as this may cause other issues.

  2. Verify that the pulleys on the X and Y-axis are properly aligned and securely tightened. Misaligned or loose pulleys can cause the print head to deviate from the correct path.

  3. Ensure the stepper motor connections for the X and Y-axis are securely fastened. Loose connections could lead to skipped steps, resulting in misalignment.

  4. Check if your print bed is leveled correctly. If it becomes unlevel during the print, it may cause the print head to veer off-center. Re-level the bed before each print to maintain proper alignment.

  5. Examine the quality and condition of your filament. Poor-quality...

WARNING: This response is AI generated and may contain errors.
finite yoke
#
  • no mods
  • using ultimaker cura slicing program
#

-using esun pla+

analog hamlet
#

your x axis belt most likely slipped.
you should check everything benchy bot mentioned ^

snow daggerBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

finite yoke