#Creality halot mage resin printer settings?

1 messages · Page 1 of 1 (latest)

lilac bane
#

I'm new to resin printing but decided to give it a try. I keep having my prints fall off towards the end.. I also am looking to figure out what speeds etc I should be aiming for here. I was told to switch to this profile to unlock the settings on it

image.png
full hawkBOT
#
AI Help

It sounds like your prints may be detaching from the build plate during the printing process. This could be due to several factors, such as improper leveling, inadequate adhesion, or insufficient supports.

To ensure better adhesion, make sure your build plate is properly leveled. Refer to your printer's manual for instructions on how to level the build plate correctly.

Using a suitable adhesive can also help with adhesion. You can try using a resin-specific adhesive such as a resin printer adhesive sheet or a glue stick. Applying a thin layer evenly across the build plate before starting the print can improve adhesion.

Additionally, ensuring that your supports are properly placed and sufficient in number can help prevent prints from falling off. Well-supported prints are less likely to detach during the printing process. Consider using support structures in areas that require additional stability.

Regarding the printing speed and settings, it can vary depending on your specific ...

WARNING: This response is AI generated and may contain errors.
lilac bane
# 

M8006 I5   ; The maximum starting speed, when the movement speed exceeds this speed, the speed will be used as the starting speed
M8007 I10   ; The maximum jerk speed when changing direction, if the actual speed of the movement is greater than this value, will force the movement to decelerate before changing direction. Large = noisy and easy to lose steps. Small = slower printing speed
M8008 I100  ; Acceleration. Large = fast, noisy, greater chance of FEP peeling issues. Small = slower, quieter, safer peeling.

M8013 I9   ; Maximum speed of Z motion
M8015 I8   ; First home speed
M8016 I1   ; Second home speed: Reducing the second zero return speed can improve the repeated positioning accuracy of the limit position, if the parameter is 0, the second zero return will not be performed

; Speed and distance of Z-axis demolding in mm/sec, AKA TMSC. During demolding, first lift slowly, then lift quickly, then pause, then retract quickly, then retract slowly

M8070 Z4   ; Total distance of each Z rise
M8070 S0   ; TSMC 1st lift distance in mm. Zero value disables the 1st lift.
M8015 P9.0 ; Max 1st lift speed
M8015 T9   ; Max 1st lift speed (unsure if used)
M8028 S9.0 ; Max 2nd lift speed  
M8016 D0   ; Number of milliseconds to wait after lift
M8016 P9.0 ; Max 1st retract speed
M8016 T9   ; Max 1st retract speed (unsure if used) 
M8021 S0   ; TSMC 2nd retract distance in mm. Zero disables the 2nd retract.
M8020 S9.0   ; Max 2nd retract speed

M8030 T-2  ; Motherboard cooling fan MB_F control, 1: follow the exposure, 0: normally closed, -1: normally open, -2: follow the print
M8085 I1000; start logo duration, minimum 100ms, maximum 6000ms
M8500      ; Save configuration permanently``` also is this right?
#

I used this gcode to increase my speed limits

full hawkBOT
#
This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

lilac bane
#

Not solved