nozzle heating issue

[cunning valley]

My printer keeps klipper crashing when I try to print whether it be the first moment it starts moving or after a few layers the printer starts dropping in heat rapidly and lipper crashes

[oak bridge]

AI Help

It sounds like you are experiencing crashes with Klipper firmware during your prints. There could be a few reasons for this issue. I suggest you try the following troubleshooting steps:

1. Make sure you are using the latest version of Klipper firmware. Check the Klipper GitHub repository for any updates and follow the instructions for updating the firmware.

2. Check your printer's wiring connections. Loose connections or faulty wiring can cause intermittent issues. Ensure that all connections are properly secured and that there are no loose or damaged wires.

3. Verify that your printer's power supply is sufficient. Insufficient power supply can lead to voltage drops, causing the printer to crash. Check if your power supply meets the recommended requirements for your printer model.

4. Review your printer's configuration files in Klipper. Double-check the settings and parameters specific to your printer, such as motor currents, max acceleration, and temperature settings. Incorrect...

WARNING: This response is AI generated and may contain errors.

[oak bridge]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[fair folio]

Check the heater and thermistor wiring

If that's fine, try doing a PID tune

[keen smelt]

Put a ?solved here if the issue was resolved elsewhere

[cunning valley]

?solved