creality spider V3 hotend settings

[sharp bear]

AI Help

I'm sorry, but I do not have specific information on the settings for the Spider v3 hotend. However, I can help you troubleshoot the issue you're experiencing. First, make sure your hotend is properly assembled and fully tightened. Then, check if there's any filament oozing or stringing during retraction. If so, you may need to increase your retraction distance or decrease your retraction speed. Experiment with different values, incrementally increasing or decreasing to find the optimal settings for your specific setup. Additionally, ensuring that your filament is of good quality and properly loaded can also impact the printing result.

WARNING: This response is AI generated and may contain errors.

[sharp bear]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[lilac coyote]

Oh man, direct drive you want below 1 mm

I have mine at .5mm, 50mm/s

[sharp bear]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

[strange rover]

I tried .5mm and 1mm retraction and the are really bad

[tepid smelt]

You dried the filament and tuned in the right order? Temperature, Flow, retraction dostance, retraction speed?

[strange rover]

yes i did that, unless the temperature changed when I switched hotends

[tepid smelt]

Pid tune the new hotend and repeat the calibrations

You changed a major piece of your printer

[sharp bear]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.