Ender 3 s1 pro not printing close enough to the bed

[compact sonnet]

every time i try and print somthing it will not get close enough to the bed and will pull up i have properly levelled the thing 6 or 7 times and it wont print on the bed. I input the gcode to use the mesh that the printer made and i think its not working and i don't know why
i have made no modifications to the printer other than updating the firmware to the newest moddel

[eager narwhal]

AI Help

It sounds like you are facing issues with bed adhesion. Here are a few troubleshooting steps you can try:

1. Double-check the leveling: Make sure the bed is properly leveled. Use a piece of paper or a feeler gauge to ensure the nozzle is at the right distance from the bed.

2. Bed temperature: Ensure that the bed is heated to the appropriate temperature for the material you are using. Different materials require different bed temperatures for proper adhesion.

3. Clean the bed: Ensure that the bed surface is clean and free from any debris or oils. You can use isopropyl alcohol to clean the bed surface thoroughly.

4. Use a printing surface: Consider using a printing surface such as painters tape, a glass bed, or a specialized adhesive sheet to improve bed adhesion.

5. Adjust Z-axis offset: Check your printer's software settings and calibrate the Z-axis offset, also known as the "first layer height" or "first layer thickness." Adjusting this value can help the nozzle get closer to ...

WARNING: This response is AI generated and may contain errors.

Is your problem solved? / No longer need this channel?
You can close a help channel with ?solved when it is no longer needed.

?close requested by: masterchief2416#0

[compact sonnet]

?solved