#SV06 bed VERY uneven after being unused

1 messages · Page 1 of 1 (latest)

jaunty light
#

Hi all, ive sadly let my Sovol sv06 collect dust for a few months, but i'm now using it again. i was getting some awful first layers when i did my first few prints, so i decided to reprobe the bed. when it was done i saw this on octopi (it was fairly even before)... any advice? its running hilsoftware (with x axis twist compensation)

Screenshot_2024-01-26_120717.png
polar dirgeBOT
#
AI Help

It looks like your bed leveling is not accurate, which can lead to issues with the first layers of your prints. Here are a few troubleshooting steps you can try:

  1. Make sure your printer's firmware is up to date. Check the manufacturer's website or community forums for any firmware updates specifically addressing bed leveling.

  2. Double-check that your probe is clean and free from any debris. Sometimes dust or other particles can interfere with accurate measurements.

  3. Re-level your bed manually. This involves adjusting the bed screws or knobs to ensure that the distance between the nozzle and bed is consistent across the entire printing surface. Use a piece of paper or a feeler gauge to help achieve the desired distance.

  4. Consider calibrating your probe. Consult your printer's user manual or the manufacturer's website for specific instructions on calibrating the bed leveling probe.

  5. If you are using any software or plugins for bed leveling, review their settings and conf...

WARNING: This response is AI generated and may contain errors.
jaunty light
#

i have checked the spacers quite a while ago, and they're all pretty even.

jaunty light
#

Do i do the soup can trick?