5015 blower recommendation

[flint island]

Real simple: I bought cheap fans and it's biting me in the butt, down 2 mosfets and a whole board at this point.

What brands of fans are good (24v)? I've been recommended:
gdstime, sunon, delta, honeybadger

[limber pagoda]

AI Help

When it comes to reliable fan brands for 3D printers, the ones you mentioned are well-known in the community. Some other popular brands include Noctua, E3D, and Corsair. These brands are known for their quality and durability, so they should serve you well.

However, it's important to note that simply replacing the fans may not be the only solution to your issue. If you are consistently damaging MOSFETs and the entire board, there might be an underlying problem that needs to be addressed. I recommend reviewing your printer's wiring setup, ensuring the power supply can handle the load, and checking for any shorts or faulty connections that could be causing the failure.

If the issue persists even with reputable fans, it would be beneficial to reach out to your printer manufacturer or seek assistance from a knowledgeable community or forum to troubleshoot and find a solution specific to your setup.

WARNING: This response is AI generated and may contain errors.

[flint island]

As an aside: I don't need help with the board/finding the issue, it was 100% a visible short in the cheap Winsynn fans.