How should I go about printing this part

[plush gazelle]

I've tried printing the part in several different ways:
on its side
standing up
Splitting it into two halves along the Z axis
Spliting it into three parts

But none of these methods could give me a satisfactory part. The issue with splitting the part is that when I try to join them back together, there is a very visible line between the parts since they don't fit perfectly together. How do I remedy this?

[toxic dagger]

AI Help

To remedy the visible line between the split parts when joining them together, you can try the following techniques:

1. Sanding and smoothing: Use fine-grit sandpaper or a sanding block to gently smooth the surfaces of the split parts. This can help to remove any raised or uneven areas, making it easier to join the parts seamlessly.

2. Filling and bonding: Apply a filler, such as epoxy putty or a compatible adhesive, to fill any gaps or imperfections along the split line. Once the filler has dried or cured, sand it down to create a smooth surface.

3. Precision alignment: Take extra care in aligning the split parts correctly before joining them. You can use alignment pins or markers to ensure accurate positioning and minimize any visible seams.

4. Post-processing techniques: Consider using post-processing techniques like acetone vapor smoothing (applicable to certain materials) or applying a primer or paint to the finished part. These techniques can help to further mask any visib...

WARNING: This response is AI generated and may contain errors.

[toxic dagger]

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.