#trouble shooting

1 messages · Page 1 of 1 (latest)

fast hound
#

so i upgraded my ender 3 with a new board and a the sprite and cr touch and it wont save the z offet and it wont stay in english and cr touch isent leveling right i know becasue my prints were fine and now they arent sticking to the bed

robust dawnBOT
#
AI Help

It sounds like you are facing a few issues after upgrading your Ender 3. Let's address them one by one:

  1. Z offset not saving: Make sure you have followed the correct procedure for saving the Z offset with the new board. Check the documentation or online resources specific to your upgraded board.

  2. Language settings: If your printer is not staying in English, you might need to change the language setting in the printer's firmware. Consult the documentation or manufacturer's website for instructions on changing the language.

  3. CR Touch leveling: If the CR Touch is not leveling properly, ensure that it is correctly installed and calibrated. Double-check that the necessary connections are secure and that the firmware is configured to work with the CR Touch. Consider recalibrating the CR Touch using the recommended procedure provided by the manufacturer.

  4. Print adhesion issues: If prints are not sticking to the bed, there could be several factors at play. Ensure that the bed is...

WARNING: This response is AI generated and may contain errors.
whole wagon
#

What kind of board did you buy

fast hound
#

32 bit

#

ender 3