#Ender 3 S1 bed leveling knob not working

1 messages · Page 1 of 1 (latest)

true hamlet
#

I just got a new Ender 3 S1 but I can't seem to level the top right part of the print bed with the adjustment knob. Every other one works fine.

static falconBOT
#
AI Help

If you are having trouble leveling the top right part of your print bed on the Ender 3 S1, here are a few troubleshooting steps you can try:

  1. Check if the print bed is properly mounted: Ensure that the print bed is securely installed and not loose or misaligned. Check for any obstruction or debris underneath the bed that might affect its levelness.

  2. Clean the print bed and nozzle: Make sure the print bed is clean and free from any residue, as this can affect adhesion and leveling. Also, check for any filament buildup on the nozzle, as this can cause uneven extrusion.

  3. Adjust the eccentric nuts: The Ender 3 S1 has eccentric nuts on each corner of the bed, which control its levelness. By slightly loosening the nuts, you can adjust the tension and hopefully level the top right part accordingly. It may take some trial and error to find the correct adjustment.

  4. Use a leveling tool: Consider using a leveling tool, such as a feeler gauge or a paper thickness measurement, to acc...

WARNING: This response is AI generated and may contain errors.
true hamlet
#

Top left. My bad

mental totem
#

If you keep turning the wheel to the right, theres no additional tension being put on that spring at all??

true hamlet
mental totem
#

*Meant left sorry

#

Are you able to remove the wheel if you put ever so slight down pressure on the wheel and keep turning it right (take a lotta turns)

true hamlet
#

I'll check

true hamlet
#

Anything else I should try?