#Ender 3 v3 se auto bed leveling

1 messages · Page 1 of 1 (latest)

trim quiver
#

so my ender 3 v3 se auto bed leveling isn't working for some reason. This is my first ever 3d printer and I followed a guide on youtube to build it but the auto bed leving function isn't working for some reason It says "bed leviing failed please check after shutdown"

manic ploverBOT
#
AI Help

I'm sorry to hear that you're having trouble with your Ender 3 V3 SE's auto bed leveling. Here are a few troubleshooting steps you can try:

  1. Ensure that your firmware is up to date. Check the manufacturer's website for any available updates and follow their instructions to install the latest firmware.

  2. Make sure that the sensor is functioning properly. Clean any dirt or debris on the sensor and double-check that the connections are secure.

  3. Verify that the sensor is close enough to the bed. Adjust the distance between the nozzle and the bed according to the manufacturer's instructions. It's usually recommended to have a small gap, around the thickness of a sheet of paper.

  4. Ensure that the bed itself is level. Use a bubble level or similar tool to check if the bed is flat. If not, adjust the leveling screws underneath the bed to correct any unevenness.

  5. Try running the auto bed leveling function again after a full shutdown and restart of the printer. This can sometimes...

WARNING: This response is AI generated and may contain errors.