Help me decide Flow rate test | 3D Printing | Page 1

reef cape Dec 28, 2023, 2:04 PM

#

Which number?
https://github.com/SoftFever/OrcaSlicer/wiki/Calibration#Flow-rate

GitHub

Calibration

G-code generator for 3D printers (Bambu, Prusa, Voron, VzBot, RatRig, Creality, etc.) - SoftFever/OrcaSlicer

livid owlBOT Dec 28, 2023, 2:04 PM

#

reef cape Which number? https://github.com/SoftFever/OrcaSlicer/wiki/Calibration#Flow-rate

#

AI Help

The number mentioned in the link you provided refers to flow rate calibration for 3D printing. Flow rate calibration is a crucial step in optimizing your print quality, and it determines how much filament is extruded during printing. By adjusting the flow rate, you can ensure accurate and consistent printing. The specific number will vary depending on your printer and the filament being used, so it is important to follow the instructions provided by your printer manufacturer or slicer software.

remote swan Dec 28, 2023, 3:21 PM

#

5

quiet cliff Dec 28, 2023, 9:42 PM

#

I‘d go with 10 and do the second calibration. Most likely somewhere between 10 and 5.

#Help me decide Flow rate test