#nozzle bumping filament and knocking it off the bed

1 messages · Page 1 of 1 (latest)

neat shell
#

so, i got an anycubic kobra 2 neo for christmas yesterday and it worked perfectly the first 3 prints but now whenever i try the filament seems to un-stick to the bed and get knocked by the nozzle whcih then makes it get stuck to the nozzle and fail the print

stuck ventureBOT
#
AI Help

It sounds like you might be experiencing an issue with adhesion between the filament and the print bed. Here are a few troubleshooting steps you can try:

  1. Make sure your print bed is clean and level. Use isopropyl alcohol to wipe the bed surface and remove any residue or oil.

  2. Adjust the bed leveling. This ensures that the nozzle is at the correct distance from the bed for proper adhesion. Follow the instructions specific to your printer on how to level the bed properly.

  3. Apply a suitable adhesive to the bed. Depending on the type of filament you are using, you can use different adhesives such as glue stick, hairspray, or a specialized bed adhesive. This will provide better adhesion between the filament and the bed.

  4. Increase the bed temperature. Some filaments, like ABS, require a heated bed to prevent warping and improve adhesion. Check the filament manufacturer's recommendations for the optimal bed temperature for your specific filament.

  5. Slow down the print speed....

WARNING: This response is AI generated and may contain errors.
neat shell
#

tried all of this /\ and it didnt work

torpid kindle
#

I had this problem on my ender to fixed it I decrease my Z offset but idk how the anycubic kobra 2 neo works

neat shell
#

tried that, didnt work

#

how low would you put it though?

torpid kindle
torpid kindle
neat shell
#

alr, ill try both of those!

torpid kindle
#

Let me know how it goes!

neat shell
#

raising the bed temperature helped a little, it still failed but it made it longer

#

trying turning the fan off now

torpid kindle
neat shell
#

didnt work

violet blade
#

Any images or even better, a video of what’s not working?