#Ender 3 v2 neo not extruding

1 messages · Page 1 of 1 (latest)

distant rover
#

Was printing a model when heard lot of clicking from my extruder and thought nothing of it checked after awhile and there was no fillament coming out of my hotend. Took the fillament out and cleaned the nosel with a needle. Tried a print again and started printing to then no longer fillament coming out the hot end,

strong stormBOT
#
AI Help

It sounds like you may be experiencing a clogged nozzle. Cleaning the nozzle with a needle is a good first step, but sometimes a more thorough cleaning is necessary. Here are a few troubleshooting steps you can try:

  1. Heat up the hotend to the recommended temperature for the filament you are using.
  2. Manually push the filament through the hotend by gently applying pressure to the extruder lever or gear. If the filament goes through smoothly, try starting a print again.
  3. If the filament still doesn't come out after manual extrusion, try a cold pull or "atomic" pull. Heat up the hotend and then let it cool down to a lower temperature (around 90-100°C for PLA). With the nozzle still warm, remove the filament and cut off a fresh section. Reinsert the filament until it stops, then apply gentle pressure while pulling it out quickly. This can help remove any debris or clogs.
  4. If none of the above steps work, you may need to clean the nozzle more thoroughly using specialized cleaning...
WARNING: This response is AI generated and may contain errors.
distant rover
#

Fillament comes out witg a manual push.

distant rover
#

?solved