#CR30 printing issues

1 messages · Page 1 of 1 (latest)

static quail
#

I’m having an issue on my CR30 where the prints on it are almost like bubbling? I’ve honestly got no idea on how I would explain it but I do have a photo any idea on how I would fix this?

IMG_5122.jpg
sturdy wedgeBOT
#
AI Help

From your description, it sounds like you may be experiencing issues with your print's surface quality. Bubbling or uneven surfaces can be caused by a few factors. Here are some troubleshooting steps you can try:

  1. Check your nozzle temperature: Make sure you are printing at the correct temperature for your filament. If the temperature is too high, it can cause the material to bubble or melt unevenly. Refer to the filament manufacturer's recommended temperature settings.

  2. Verify the cooling fan: Ensure that the cooling fan is functioning properly and blowing air onto the printed object. Insufficient cooling can cause the layers to merge or deform, resulting in a bubbly texture.

  3. Check the filament quality: Poor-quality or moisture-absorbed filament can create inconsistencies in the print. Make sure your filament is stored in a dry environment and hasn't absorbed moisture. Try using a fresh spool of filament or dry out your current filament before printing again.

  4. Adjust p...

WARNING: This response is AI generated and may contain errors.
sly ether
static quail
#

I’ll try changing filiment you know how it turns out

static quail
#

It looks like it’s still having the issue with a new spool and I don’t think it’s a temperature issue because it only 200C

#

Nevermind that’s my bad spoke too soon but looks like it may an issue but only one part of the print? Not sure why that would happen

IMG_5124.jpg