#new bambulab p1s weird blobs and lines on the print

1 messages · Page 1 of 1 (latest)

craggy vortex
#

The lines can be seen on the corner of the print and this is the first time it’s happened.

IMG_7751.jpg
tribal cosmosBOT
#
AI Help

When you see lines on the corners of your 3D prints, it could be due to several factors. Here are a few common causes and potential solutions:

  1. Z-axis alignment: Make sure your Z-axis is properly calibrated. If not, it can cause layer shifting and lead to visible lines on the print. Recalibrate or level your build plate to address this issue.

  2. Over-extrusion: Excessive filament being extruded can result in bulging and uneven layers, leading to visible lines. Check if your extrusion settings are accurate, and calibrate the extruder steps/mm if necessary.

  3. Inconsistent filament flow: Ensure a steady and consistent flow of filament. Inconsistent flow or partial clogs in the nozzle can create uneven layers and lines. Clean the nozzle and check the extruder for any issues.

  4. Cool down periods: Consider adding cooling down periods between rapid movements or retracting filament to allow the print to settle and reduce the likelihood of lines appearing.

  5. Mechanical issues: Chec...

WARNING: This response is AI generated and may contain errors.
craggy vortex
#

220c extruder 55c print bed

#

Flow calibrated