#Constant Leveling Looping

1 messages · Page 1 of 1 (latest)

compact dagger
#

This just randomly happened with no changes made to the printer so I’m hoping it’s a fast fix. The leveling z-offset sequence that happens whenever I need to re-level it is constantly looping. Why is that and how can I fix it?

The video in the following is what happens just after what should have been the leveling sequence finishing.

Printer: Ender 3 S1
This error happens when I just press “Level” as opposed to starting a print. It goes on continuously, instead of ending the sequence and letting me modify the z-offset.

ember bladeBOT
#
AI Help

It sounds like you are experiencing a looping issue with the leveling z-offset sequence on your Ender 3 S1 printer. Here are a few steps you can try to fix this problem:

  1. Check the printer's firmware: Make sure that you are using the latest firmware version for your printer. If not, consider updating the firmware to see if it resolves the issue.

  2. Power cycle the printer: Try turning off the printer and unplugging it from the power source for a few minutes. Then, plug it back in and power it on again. Sometimes a simple restart can fix such issues.

  3. Check the leveling sensor: Verify that the leveling sensor is functioning correctly. Ensure that it is properly connected and not damaged. You may also want to clean the sensor's surface and the bed surface to eliminate any potential interference.

  4. Check the leveling sensor's wiring: Inspect the wiring from the leveling sensor to the printer's control board. Look for any loose cables or frayed wires that could be causing a con...

WARNING: This response is AI generated and may contain errors.
compact dagger
#

Have tried to whole turn on/off, and am not noticing any wiring or debris issues

compact dagger
#

?solved