think my printer prints wrong/skips layers

[hot stone]

The title says it all, what to do. It's been happening for months now and it keeps generating these strings . the resin I am using rn is the anycubic water wash resin

[versed sapphire]

AI Help

It sounds like you're experiencing an issue with stringing in your 3D prints using AnyCubic Water Wash Resin. Stringing can occur due to various factors such as incorrect resin settings, insufficient curing time, or inappropriate exposure settings. Here are a few troubleshooting steps you can try:

1. Check your exposure settings: Make sure the exposure time and layer thickness settings are compatible with your resin. AnyCubic provides recommended settings for their resins, so refer to their documentation or website for the correct settings.

2. Clean your print bed: Ensure that your print bed is clean and free from any debris or residue that may interfere with the printing process.

3. Adjust the curing time: If you notice that the resin is not fully cured, try increasing the curing time during the printing process. This can help reduce stringing by allowing the resin to solidify properly between layers.

4. Consider temperature and humidity: Extreme temperature and humidity condit...

WARNING: This response is AI generated and may contain errors.

[hot stone]

The supports were made in chitubox and sliced with the anycubic software