Reading my Ender 3 V2 Benchy

[twin topaz]

This is my second benchy, I think I already fixed the bottom letters by fixing my z offset, but this one has a lot more stringing than the first, and some weird blobs wherever a line ends, I did increase my hotend temp between prints from 200 to 210

[outer fractal]

AI Help

Stringing and blobs can be common issues in 3D printing. Here are a few suggestions to troubleshoot these problems:

1. Stringing: Stringing occurs when filament drips or oozes during travel moves. To reduce stringing, you can try the following:

   • Lower the printing temperature: Decreasing the temperature can help reduce the viscosity of the filament, minimizing the stringing.
   • Enable or increase retraction: Retraction helps by pulling back the filament when the nozzle moves between non-printing areas. Enable retraction in your slicing software and try increasing the retraction distance and speed.
   • Check travel speed: High travel speeds can cause filament to leak. Lowering the travel speed can help reduce stringing.

2. Blobs at line ends: These blobs occur when the extruder lingers at the end of each printed line. Here's what you can do:

   • Adjust retraction settings: Ensure that you have adequate retraction settings enabled to minimize filament oozing during non-print...

WARNING: This response is AI generated and may contain errors.

[twin topaz]

Here's the bottom I just printed, it still seems a bit off but it's better

[hard topaz]

https://www.simplify3d.com/resources/print-quality-troubleshooting/

that should set you up