Adhesion layer issues! | 3D Printing | Page 1

full blade Nov 21, 2023, 11:54 AM

#

I am very new to 3d printing got my printer today i have the ender 3 s1 pro and i was printing one of thos xyz cubes when my first adhesion layer detached causing a hair ball bwlow is what the adhesionlay looks like all sepersted and weird how do i fix this?

azure jacinthBOT Nov 21, 2023, 11:54 AM

#

full blade I am very new to 3d printing got my printer today i have the ender 3 s1 pro and ...

#

AI Help

It sounds like a common issue known as adhesion failure. There are a few things you can try to fix this problem:

Bed Leveling: Make sure your printer's bed is properly leveled. Use a sheet of paper and adjust the bed screws to ensure the nozzle is at the correct distance from the bed.
Bed Temperature: Some filament materials require a heated bed to promote adhesion. Check the recommended bed temperature for the filament you're using and ensure it's set correctly.
Print Surface: Consider using a different print surface to improve adhesion. Build surfaces like glass or a special coating like PEI or BuildTak can provide better adhesion.
Clean the Bed: Ensure that the print bed is clean before starting a print. Use isopropyl alcohol or a similar cleaning agent to remove any grease, residue, or fingerprints.
Improve Print Bed Adhesion: If the above steps don't work, you can try using a brim or a raft. These features add extra material around your print, improving adhe...

full blade Nov 21, 2023, 11:55 AM

#

rn_image_picker_lib_temp_7557ca5e-d800-4d91-96d8-73f813d24ca9.jpg

azure jacinthBOT Nov 21, 2023, 12:01 PM

#

Leveling Your Printer
Here is a handy infographic that will help with levelling your printer.

leaden ore Nov 21, 2023, 12:01 PM

#

looks like you are a bit too high

full blade Nov 21, 2023, 12:01 PM

#

?

#

like the nozzle

#

so i should put it down by 0.05mm

leaden ore Nov 21, 2023, 12:03 PM

#

or raise the bed commensurately

full blade Nov 21, 2023, 12:03 PM

#

Yeah i tryed to bed level i do have the touch sensor as well i just dunno if i did it correcrty

#

rn_image_picker_lib_temp_1e4a7387-06c9-4029-b22f-257c593f10a6.jpg

#

Gonna try more down

#

@leaden ore how about this is this good?

rn_image_picker_lib_temp_8e53fd6b-cd25-4ec3-8f29-52b8b27933c1.jpg

leaden ore Nov 21, 2023, 12:14 PM

#

the first layer lines need to touch

#

there are still gaps

full blade Nov 21, 2023, 12:16 PM

#

More lower?

#

Also i am printing pla at 200c and 60c bed

#

rn_image_picker_lib_temp_ee5e3922-8e19-4313-941b-517d277caf61.jpg

#

I have gon down about 0.3mm

#

Its getting close

#Adhesion layer issues!