kindred lichen
Printer : Labists X1
Slicer : Orca and Cura
So I have done some tests. My prints are mirrored on both the X and the Y.
The home on Octoprint is not the same as G1 x0 y0.
The home on Octoprint does engage both limit switches.
0,0 only engages the limit switch on the gantry arm and not on the bed sling.
Is this a firmware issue? or a hardware issue?
The limit switches are in the "correct" position in the sense that they can't be put elsewhere without modification.
I assumed the motor was wired backwards or the belt was backwards but with Home and 0,0 being diffrent I'm more lost.
balmy anchor