#I need help with stringing

1 messages · Page 1 of 1 (latest)

summer ore
#

Hello! I have encouuntered a problem, I couldn’t load up filament as it got stuck after like 0,5cm.
So I tried to take off the extruder and clean it,by thatI managed to get out 4pieces of different filaments,put it back and this weird curling started happening.
After a while the curling stopped almost completely and the printing started working properly. It worked for like an hour and then it progressivelly stopped basically completely.
So I tried to unload the filament to see if it’s a different issue than before the disassebly but no,after unloading,I tried to losdthe filament back in but again it wouldn’t let me.

I’m suspecting some sort of clog happening inside of the hotend and/or nozzle but what puzzles me is why I can’t insert the filament before and after I put it back.
After the disassembly and assembly,I could put it normally but now it’s not working again,I don’t know what’s the issue or what to do.Someone please help.

IMG_4597.jpg IMG_4604.jpg IMG_4605.jpg
gusty epochBOT
#
AI Help

It sounds like you may have a clog in your hotend or nozzle. Here are a few troubleshooting steps you can try:

  1. Heat the hotend to the recommended temperature for the filament you are using.
  2. Use a small needle or a piece of cleaning filament to carefully clear out any debris or filament stuck in the nozzle. Be gentle to avoid damaging the nozzle.
  3. If the filament still won't load, try heating the hotend slightly higher than the normal printing temperature and gently pushing the filament into the hotend while it's hot. This can sometimes help clear any obstructions.
  4. If the problem persists, you might need to disassemble the hotend and clean it more thoroughly. Refer to your printer's user manual or manufacturer's instructions for guidance on how to do this properly.
  5. Make sure your filament is properly fed into the extruder and the gears are gripping it correctly.

If the issue continues after following these steps, it may be helpful to consult with the manufacturer or s...

WARNING: This response is AI generated and may contain errors.
summer ore
#

I can’t push anything inside the nozzle qwq