acceleration tuning failure | 3D Printing | Page 1

alpine silo Nov 4, 2023, 3:27 AM

#

Trying to tune my acceleration control settings with the TeachingTech calibration tool. However, the print keeps failing and I am unsure which setting I would cause it do so in this way. If anyone has experience using that website or can deduce the issue from the pictures that would be great.

broken groveBOT Nov 4, 2023, 3:27 AM

#

alpine silo Trying to tune my acceleration control settings with the TeachingTech calibratio...

#

AI Help

I'd be happy to assist you with troubleshooting your 3D printing issue. Could you please provide more details about the problem you're facing and share any relevant pictures or error messages you've encountered? This will help me in assessing the situation and providing you with the best possible guidance.

broken groveBOT Nov 4, 2023, 4:30 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

alpine silo Nov 4, 2023, 4:37 AM

#

Bump

broken groveBOT Nov 4, 2023, 5:40 AM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

alpine silo Nov 4, 2023, 3:14 PM

#

Bump

broken groveBOT Nov 4, 2023, 4:15 PM

#

This post has been closed due to inactivity.

This post has been inactive for over 1 hour and so has been closed. To reopen this post simply send another message.

#acceleration tuning failure